Guess we’ll just have to wait 😄

Why can’t it say what the job is 🧐🧐🧐

I don’t think there is really. I haven’t even encountered many good Foss launchers except Lawnchair.

I see. It seems a good option for an enclosed printer for the price. I feel a bit uncomfortable with manufacturers selling machines with locked down open source software though 😖

Does the Kobra use Klipper, and do you have SSH access?

[Solved], but what was your solution 👀

Waydroid: a container-based approach to boot a full Android system on GNU/Linux

Zero click here - basically a klicky too! Fantastic if you don’t feel like using a build plate.

I cancelled the other objects that were supposed to print after, but left these because I thought any damage would be done already. Luckily, no damage and no waste!

What sort of probe were you using on your ender?

I highly doubt your nozzle is worn out unless you’ve been printing with any special tough filament (e.g. carbon fibre core). It’s completely different machine, but I have over 300 hours on mine and I haven’t had to replace the original brass nozzle yet.

Edit: Perhaps try printing a solid section of only the first layer (no need for the whole bed, but make is fairly large). See if the lines mostly all join up, then reprint without changing anything to check if it is consistent.

I found the fuse, but it wasn’t blown 🥲 I’ve looked over the board, and watched some repair videos but I haven’t found anything. I’ve called it dead now.

Nope, no signs of life with the battery removed and on wall power only. I believe the battery was not to blame, but something went wrong that caused it to also drain the battery. I will check the battery anyway and report back if I find anything interesting. Thanks for the helpful link.

Ah, I realise my wording was very confusing there. I meant: Because the inductor is NOT the problem - I don’t have any idea what the problem is - therefore the LAPTOP is dead (not the inductor)😂

That’s a great tip, but unfortunately the power supply is not turning off. I will refer to this next time though 👌

Current passes through it unfortunately, maybe it’s possible there is a short between coils though. The inductor doesn’t get hot or anything when plugged in.

• I think I’ve managed to check the battery voltage, and it seems completely dead (mV).
• I can measure 20v on the PCB whe n plugged in.
• No fan, no LEDs, etc with either power source. There might be the slightest electrical squeek from somewhere, I will try and find out what …

Even if I don’t manage to fix it. Thanks for the suggestions 👍

Great advice, but unfortunately I’ve checked. 20V from the supply (measured on the laptop PCB), everything removed except the ram because I only have one compatible stick - I did swap the slot though.

Just the continuity test 😅

Thanks. I guess I was just hoping it would be an easy find and fix. The beep confirmed hope is lost 🥲

I’ve never visited the site before so I just assumed it was just malicious, but as @zdanger said, it might be a hijacked legit site.

I do use uBlock. It also didn’t ‘feel’ like an ad. I now expect the site was compromised as you suggested.

Thanks for that. I also didn’t know about that shortcut until now. It will be very helpful 👍😁